About icyice

icyice · 12-30-2019

Hello,I have put together a small testlab for educational purposes containing:Cisco 877/878/800As.These are soho routers with the ethernet being non manageable which means all the Fastethernet0-4 ports cannot have IP addresses and you can only set ve...

icyice · 01-04-2019

Hello, I would like to configure video stream between Cisco 8945 phones and regular softphone clients such as: Jitsi, Bria, Qutecom, Ekiga. So far my experience with the SIP894x.9-4-2SR2-2.loads firmware is that when a video is being requested the ph...

icyice · 01-03-2020

Hello, Yes I can post it however if what you say is true this setup will never work as I intended it to work. In this setupR3 is the exit point with a network 172.16.22.0/24R4 is the entry point what I use with my laptopand R1 and R2 in between. I co...

icyice · 01-02-2020

Thanks for the response, you were right it only forms neighbors on the primary IP which sadly ruins my test. In my test all the routers connected to a management network with a single cable 10.0.0.0/24 which is going into a regular switch. I have set...

Member Since	‎01-04-2019 03:39 AM
Date Last Visited	‎01-07-2020 07:46 AM
Posts	4

User Statistics

User Activity

RIP OSPF does not activate on secondary IPs

ip phone 8945 crash/reboot from h264 video stream

Re: RIP OSPF does not activate on secondary IPs

Re: RIP OSPF does not activate on secondary IPs