Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have WLC 9800-80 and use a third-party server to authenticate guest clients using guest portal. When a client try to authenticate, they get IP address but the guest portal behave differently every time we try to login. These behaviors happen wi...
Hi!We are implementing dot1x authentication with Cisco ISE and MS120, MR33 and MR46. Every thing works fine but we can't implement Fail Open. Our goal is that when Meraki switch or AP lose connection with Cisco ISE, like Cisco classic switches, use F...
Hi,We have different networks in a same template with autovpn between them. We want to isolate a subnet in (VLAN10) so it can't communicate with RFC1918 addresses in the network BUT we want that all vlans10 in other networks can talk to each other. W...
Hi,Uplink switchport in our MS120-48LP (SW2) change continuously status from designated→root and root→designated.we lost connectivity with SW2 for almost one day and suddenly it came up during last night and after two hours it stopped with the STP s...
Hi everyone,
I have configured a Radius server and want to manage my switches (Catalyst 2960-X) with users in AD. It works fine but the only way I can do the authentication is when I choose "unencrypted authentication (PAP,SPAP)" in Radiusgrupp prop...
Thank you Arne,
I will try DTLS and see how it works. We will extend the radius authentication over the entire network with multi-vendor devices. Is DTLS suitable for a multi-vendor environment (Cisco, Dell, HP, MikroTik)? Or there is a better protoc...
