Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a L2L VPN tunnel setup for the 6.0.85 subnet which is required by the end user. Putting in the static NAT for 10.24.74.217 it cannot get out to the Internet now, since the 6.0.85 is a public subnet and not on the outside interface of the firew...
Currently have six WLC2006 and three just went bad after four years is that about the standard for these going bad? Anyone esle have the same failures with these?ThanksJerrod
I think I figured it out I create access lists for that IP only to that range and applied them to the static NAT and removed the old ones.access-list policy_nat_mckesson_2 extended permit ip host 10.24.74.215 6.0.87.0 255.255.255.0 access-list policy...
