Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a AIR-SAP2602IA-K9 access point that is loaded with 15.3(3) JBB (ap3g2-k9w8-mx.153-3.JBB). I have ap3g2-k9w7-mx.153-3.JC copied into flash (15.3.3-JC) but cannot seem to get it to load.
In ROMMON, I set the BOOT variable to flash:/ap3g2-k9w7-...
I am running CNA 6.2 and am trying to add a WS-C2960S-24PS-L switch to an existing Community. Every time I try to add the switch I get "Authentication Failure".
I can bring up the switch just fine on its own in CNA and fully configure it, but I can...
Not a big issue at all....I have the latest version of Cisco Network Assistant running. I have aseries of 2960G switches connected in a community. I also have a 1240 series Access Point in the community as well. So far a total of 6 devices.I have ...
I have a cluster of seven 2960G switches. On six of the switches I have set the hostname succesfully. On the seventh switch, I can set the host name, and everytime the switch is reloaded, it gets renamed with a name that is a variation of the comma...
I have a bunch of AIR-ANT1949 13dBi Yagi antennas. I live in the upper Midwest and the wind and ice really take a beating to these things. Is there a product similar (3rd party maybe?) to this that would be a little more rugged? I'd like to stick ...
If I create a new community, then the switch connects just fine with all the other switches. Weird.
Maybe I'll just delete the community I have and create a new one.
I only have about 12 items in my Community.
And I have tried, what I think is ready only mode, and there's no difference. Maybe I should try an earlier version of CNA?
