Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,I have an issue with some C9124AXI APs. Some of them can associate well but a couple of them are stuck in provisioning procedure.Image download went well in both case, but after that it shows "Response build failed".Here is the log:%CAPWA...
Hi Guys,I didn't find a solution for my bridge system's bug.There is a small mesh system with 1 RAP and 4 MAP.All of them are C9124AXE APs with 6 antennas.The WLC is a C9800-40-K9, ver: 17.12.4Almost everything is working except the slot 2 radio sett...
Hi Everyone,I have a trouble with a 9124AXE mesh system.My problem is the following: I can not set the RF Channel of slot 2 radio...The second radio itself is working,but only with "global" assignment method.Fun fact: If i set the same parameters in ...
Hi Everyone,So we've just installed a new outdoor mesh system with WLC 9800 and APs 9124AXE.See the layout below.After configuration we are experiencing huge noise (in DNA the APs health is 1) both in case of 2.4 and 5 GHz spectrum.Besides it the wir...
As in my question, I have to give priority for IP phones, but there is no other vlan just the default. So somehow i have to give priority for the ip addresses of the voip phones. Can i manage it with QOS? Thank you for the answers and sorry for the s...
Here is a part from AP's CLI:[*04/11/2025 07:32:54.2110] CAPWAP State: Join[*04/11/2025 07:32:54.2390] shared_setenv PART_BOOTCNT 0 &> /dev/null[*04/11/2025 07:32:54.6721] Sending Join request to CORRECT_WLC_IP through port 5248, packet size 1376[*04...
Both working and not working APs are brand new and they are both connected to the same staging switch with the same VLAN / Subnet. So it shouldn't be the source of the issue. Discovery is working, it wants to communicate with the controller. As i sai...
Thanks! I will collect the logs asap.The last thing you wrote, I did it. So i've set the primary controller on production WLC gui to move to the office WLC.
