About efjadmin

efjadmin · 02-25-2019

I'm replacing EOL 2960 FastE switches with 2960-X GigE. The old switches are configured with a trunk port uplink to the management network and accessed via the VLAN IP address. I have been unable to connect to the new switches when I try to configure...

efjadmin · 02-28-2019

I figured out the problem. Though I had made sure the trunk ports and vlan interfaces were configured, I had failed to enable the vlan itself. I was able to connect after adding the following: engdevrack(config)#vlan 100engdevrack(config-vlan)#state ...

efjadmin · 02-26-2019

other side:VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Gi1/0/13, Gi1/0/24, Gi1/0/26, Gi1/0/27Gi1/0/28, Gi2/0/9, Gi2/0/24, Gi2/0/25Gi2/0/26, Gi2/0/27, Gi2/0/2811 RedBlueInterfac...

efjadmin · 02-26-2019

Sorry about the 1/0/24 output. 1/0/3 is the other end. Here's the 1/0/1 status:engdevrack#show int GigabitEthernet1/0/1GigabitEthernet1/0/1 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 6c6c.d3bf.c081 (bia 6c6c.d3bf.c...

efjadmin · 02-26-2019

Here's the port on the other side:interface GigabitEthernet1/0/3description eswrackredswitchport trunk encapsulation dot1qswitchport trunk native vlan 100switchport mode trunkspanning-tree portfastspanning-tree link-type point-to-point #show int Giga...

Member Since	‎02-25-2019 07:27 AM
Date Last Visited	‎02-18-2020 07:07 AM
Posts	5

User Statistics

User Activity

Replacing v12.1 FastE top-of-rack switches with v15.2 GigE

Re: Replacing v12.1 FastE top-of-rack switches with v15.2 GigE

Re: Replacing v12.1 FastE top-of-rack switches with v15.2 GigE

Re: Replacing v12.1 FastE top-of-rack switches with v15.2 GigE

Re: Replacing v12.1 FastE top-of-rack switches with v15.2 GigE