Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
for the first time I am going to run nbar on my router which is a 7604 with sup" WS-SUP32-10GE-3B "
I want to discover the amount of "HTTP" traffic on my router ( which is my edge router to the internet)
my question is that:
1.does it impose a lo...
Hi Guys,I need to know if there is a way to checl the IPs which are blocked to pass through the ASA 5520 firewall.this firewall is doing the NAT for 3 IPs for me192.168.20.21 -----NAT---->10.10.20.21192.168.20.22 -----NAT---->10.10.20.22192.168.20.23...
Hi Guys , How to set Router-ID in IS-IS ? I am going to Use IS-IS in MPLS SP Network and my IGP is IS-IS . I want to know How to set Router-ID in IS-IS ? Thanks .
I have conected two cisco 7200 routes via one serial interface.I am going to create two subinterfaces in each of them assign them IP address and connect them via (two BGP neighborship)the fact is that they cannot even ping eachother though they are d...
thanks for your time .so how to set router-id in Service providers NW routers , as you know if we do not need to monitor the p routers in MPLS VPN network( IGP :ISIS ) we will not run BGP on the P routers so how to configure ( Hard Code )router-id on...
Thanks Imran Khan . your answer is great and absolutely right.thanks for answering very fast .as I see this is the only thread in the whole internet that solves this issue .Thanks alot
