About Darrinmc

Darrinmc · 02-27-2019

Hi all, I am attempting to connect 3 routers to a main router as part of a larger setup.the relevant IP addressing table is :Router1 (on F0/0/1) 192.168.3.2/26Router2 (on F0/0/2 192.168.3.66/26Router3 (on F0/0/3) 192.168.3.130/26Main Router F0/0/1 -...

Darrinmc · 02-28-2019

Thanks for taking the time to review. ERROR MESSAGEHQ(config)#int vlan 20HQ(config-if)#%LINK-5-CHANGED: Interface Vlan20, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan20, changed state to upHQ(config-if)#ip address 192.168.3...

Darrinmc · 02-28-2019

ERROR MESSAGEHQ(config)#int vlan 20HQ(config-if)#%LINK-5-CHANGED: Interface Vlan20, changed state to up%LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan20, changed state to upHQ(config-if)#ip address 192.168.3.65 255.255.255.192% 192.168.3.64 over...

Darrinmc · 02-28-2019

I must be misunderstanding subnets ? I would think these are all on the same subnet ?192.168.3.2/26192.168.3.66/26192.168.3.130/26192.168.3.1/26 192.168.3.65/26 192.168.3.129/26 You said only 2 are on subnet 192.168.3.0/26 ? Which would they be?

Darrinmc · 02-28-2019

Thanks for taking the time to review. This is the error message when I try to assign IP to VLAN 20, and then config for HQ and R1. both connected via F0/0/1. The same happens when I do the same for R2 and R3, ERROR MESSAGEHQ(config)#int vlan 20HQ(co...

Member Since	‎02-27-2019 02:15 AM
Date Last Visited	‎03-02-2019 02:48 AM
Posts	5

User Statistics

User Activity

ip vlan overlapping

Re: ip vlan overlapping

Re: ip vlan overlapping

Re: ip vlan overlapping

Re: ip vlan overlapping