About LANSK

LANSK · 02-15-2020

Hello Experts, I am am setting up an asa 5508 in transparent firewall. Created a BVI interface and join two inside interfaces to bridge. I am after to create an ACL that can permit only one host per interface Interface BVI 44ip add 10.1.1.3 255.2...

LANSK · 02-13-2020

Hello guys, I am configuring a Firewall (transparent mood) in between PLC and Field Bus Module ( Modbus to TCP, port 502 ). PLC and Field Bus Module are in the same ip range and both are connected to firewall port 1 and 2. Firewall's port 1 and por...

LANSK · 02-09-2020

Gents , I have a ASA 5506 Firewall work as a transparent mood. I am trying to add ACL to port 1 and 2 to accept only 2 specific ip address to that port.this ASA have BVI interface that assigned to PORT 1 and PORT 2 on the firewall.ASA giga Port 1 m...

LANSK · 02-08-2020

Experts, I have configured ASA 5505 -x firewall on a transparent mood with BDV interface. I assign port 1-2 for same bridge group. But when i connect to firewall in to two devices. firewall's port lights indicate green color but they are blink...

LANSK · 05-08-2019

Hello Experts, I am in the middle of task that required to activate ASA 5545 Firewalls. I have received the Licence files from cisco. In the email it was written that will required cisco Defence Center for to upload the licence file to firewalls. Pl...

LANSK · 02-16-2020

Hello Balaji, thank you for the reply. sure ,let me share the full config .!firewall transparentinterface GigabitEthernet1/1bridge-group 44nameif insecurity-level 100!interface GigabitEthernet1/2bridge-group 44nameif in2security-level 100!interface...

Member Since	‎03-19-2019 06:34 AM
Date Last Visited	‎07-29-2020 12:06 AM
Posts	6

User Statistics

User Activity

ACL for Transparent ASA Port

ACL for two interfaces on Firewall

Can not get ACL work on AS Firewall

ASA 5506 Lights blinking meaning

Firewall Activation

Re: ACL for Transparent ASA Port