Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have just been provided a new voice line by provider. I have put an initial config on the e1 controller card and once i got the Channel group configured I put a config on the serial interface. i am a little unsure of how to progress the config a...
Hi,I am trying to get domain users to authenticate to my network via Active directory but i cannot get this running. local user accounts on the ASA are working fine.I have a tunnel group and policy but i am struggling with getting it to talk to AD.be...
Hi All,Just wondering if its possible to configure Server load balancing via a Virtual IP on Cisco Firewalls? If so my plan is to use a NAT'd VIP with 3 Windows Servers in a pool with the same configuration. I would like to a Weighted Least Connectio...
Hi,I am looking to create a vlan for visitors to my network to isolate them from the LAN. Below is the breakdown of my LAN.IP Range:192.168.16.0 - 254 - LAN Devices. (VLAN1)172.21.60.0 - 254 - IP Telephony Devices.(VLAN10)The gateway is my CME 192.16...
Hi.I have an ASA5510 talking to a Cisco 800 Series router with Bootstrap version 12.3 providing a site to site VPN. I am seeing intermittent drops in the connection and the transfer rates are very low.87MB's is transfering at between 80 & 90K per sec...
Hi Guy's,thanks for your suggestions here. I have managed to get this one resolved and below is the configuration applied to the card. hope this helps somebody else.Assuming this is just an E1 card (and not a T1/E1 card), you'll need to do a few thin...
Hi,I am testing from the 800 to the 5510 and to another 5505 in another site. Mesh topology in use here.I have checked the interfaces and there are no collisions or duplex mismatches.A test from both locations shows me taking almost 35mins to copy a ...
Hi Aaron,Thanks a million for that. It has reduced the noise quite a bit but there is still some noise on the line. would it be worth my while playing with the gain and attenuation?Paul.
Thanks,I think where it gets confusing for me is configuring a Dial-peer group for the ports and mobile networks as it seems to be different than creating groups for POTS lines.Paul.
