Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Initially we only suffered this on the MS425 despite Meraki extended the impact to some other MSXXX series. The solution proposed was a combination of new firmware release (but as you will see it is not yet available as stable, only as beta) with ...
Thanks a lot for the feedback @Andy Howard.In our case we are facing the same situation with additional problem on top. We insert the Copper SFP until possible, the SFP is detected by the MS, the port provide link and everything works. But, if that l...
Hi @Andy Howard ,One question. Independently of not being able to reach the lock in mechanism with the SFP are you still able to get link from the switch?
Hi @DarrenOC,I was providing the 8 sensor per MV or MR number based on the MT Frequently Asked Questions webpage from Meraki.Regarding the question "How many sensors can be used per gateway?" it is stated that it is recommended to have a maximum of 8...
Hi NGleich,As far as I know the MV and MR are able to support up to eight sensors each to ensure connection quality. I suppose it is not yet enough for what you are looking for but it is a little bit more than six anyway.Hope it helps,KR,Raúl
