Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I am experiencing an intermittent connectivity issue in an environment with Cisco ASA firewalls in failover mode and Nexus 5K switches configured with vPC. I would appreciate any insights or confirmation of possible root cause scenari...
Hello there!I get a doubt and would like to count on your support to be able to fix it.I currently have a customer with a Cisco ASA 5516-X the firewall is running the 9.12(4) ios version with 7.15(1) asdm version and the customer is requesting the up...
Hi there,I am trying to add our WLC 9800 in DNA Center, but for some reason we're the NETCONF isn't working. NETCONF is already configured on the WLC with the SNMP community is fine until here. When I go to the DNA Center and try to validate the cred...
Hi there,I am trying to add our WLC 9800 in DNA Center, but for some reason we're the NETCONF isn't working. NETCONF is already configured on the WLC with the SNMP community is fine until here. When I go to the DNA Center and try to validate the cred...
Hello there!I currently have a 9800 WLC and now we'd like to enable/configure aWIPS on the network only on three APs.My doubt here is, do we need to configure a Rogue Policy? it is necesary?If anyone knows what the correct process is to configure aWI...
At the moment we have observed the ARP behavior during the incident windows, however the entry appears to become unreachable from the ASA perspective rather than showing a clear MAC change or flapping condition.After clearing the ARP table, the ASA r...
Hello there!That actually aligns with something I found during troubleshooting.I identified a VLAN inconsistency on the Port-Channel toward the ASA:VLAN 119 (and potentially others) was allowed on the Port-Channel on one Nexus (TC), but missing on th...
Thanks for the feedback.Here are additional details from my troubleshooting:ASA model: Cisco ASA 5525-XFailover is working correctly and stateful sync looks healthyNo failover or interface flaps occur during the issueI performed further checks on the...
Ok gotcha, I will go ahead and will modify the tacacs config, I will put the aaa local and finally add again the tacacs config.I come back tomorrow and I will put it here my inputs.
Hi,Let see if I understood, what I have to do is remove my tacacs configuration and use the local auth, then reconfigure the tacacs authentication, is it?
