About ferdy

ferdy · 08-05-2019

Hi,We would like to setup an IPSec tunnel between an MX84 pair and a fortigate 70D. The Fortigate is behind a NAT device which allows IPSec. Error message at the Fortigate is: Negotiation failure. At the Meraki side: phase1 negotiation failed due to...

ferdy · 06-21-2019

Hi,I configured around 180 AP's in 1 organization with static IP addresses and static DNS. I would like to change only the DNS settings for all AP's, using API (with Postman app). I cannot change to DHCP because of monitoring systems. Anybody got any...

ferdy · 08-05-2019

It Works! It was in the config of the Fortigate. Needed to build an extra phase 2 tunnel instead of putting 2 subnets in one phase 2 configuration.

ferdy · 06-22-2019

If you PUT the following with Postman:{"wan1": {"staticDns": ["208.67.222.222","208.67.220.220"]}}Only the DNS changes from the previous values to (in this case) the Cisco Umbrella (OpenDNS) values. It leaves the other "wan1" values as they were, so ...

ferdy · 06-21-2019

Just did the first test and the AP comes back with the following:{"wan1": {"usingStaticIp": true,"staticIp": "192.168.1.3","staticSubnetMask": "255.255.255.0","staticGatewayIp": "192.168.1.1","staticDns": ["8.8.8.8","8.8.4.4"],"vlan": null}}Looks pro...

ferdy · 05-27-2019

Reset the switch to factory default:https://documentation.meraki.com/zGeneral_Administration/Support/Resetting_Cisco_Meraki_Devices_to_Factory_DefaultsConnect one of the switchports to the internet modem/router that can provide a DHCP address to the ...

ferdy · 05-27-2019

If the switch is "out of the box", connect on of the switchports to the internet. For example an internet router/modem that can provide the switch with an IP address. This is the only way the switch can connect to the Meraki dashboard. Connect to the...

Member Since	‎04-10-2019 12:15 PM
Date Last Visited	‎05-22-2019 12:07 AM
Posts	7
Total Helpful Votes Received	9

User Statistics

User Activity

Meraki MX84 IPSec tunnel Fortigate 70D

Change DNS settings on AP's with API

Re: Meraki MX84 IPSec tunnel Fortigate 70D

Re: Change DNS settings on AP's with API

Re: Change DNS settings on AP's with API

Re: configure an uplink port

Re: configure an uplink port