About SecurityJumbo

SecurityJumbo · 09-30-2024

Hello team,I'm using the following information for the CUCM to check the service status but it is failed and return the error message below. Please advise if I'm missing anything or this is a know issue with CUCM version 14.0 (my CUCM running (14.0....

SecurityJumbo · 08-31-2023

Hello everyone,I'm trying to understand how the Firepower and NAT are working together. I have Firepower is configured with static and default route. It is working fine if I have the NAT policy configured, but when I remove the NAT rule the Firepower...

SecurityJumbo · 06-24-2023

Hello guys,I'm deploying the ISE posture policy and I run into the AnyConnect Posture return "No Policy Server Detected" as shown below. The switch and machine are able to reach to the ISE ip and dns name.I created the ISEPostureCFG.xml file and save...

SecurityJumbo · 05-06-2023

I have a FMC and HA FTD on HA mode version 7.3.1for both. The DNs server is connected via INSIDE interface only. The Firepower can ping the DNS server as shown below, but the DNS is failed. I configured the DNS and domainsearch. The DNS is not resolv...

SecurityJumbo · 12-03-2022

Hello guys,I have been using ISE radius policy to assign the Security Group and it was working fine. Now, I'm using a third part tool to assign the SGT on the cisco switch interface (access port) using the SSH connection and keep the TrustSec policy ...

SecurityJumbo · 10-02-2024

Hello @DavidStaudt Thank you very much for your response. I updated the request quesy as the following curl -k -v 'https://X.X.X.X:8443/controlcenterservice2/services/ControlCenterServices?wsdl' \--header 'Content-Type: text/xml;charset=utf-8' \--he...

SecurityJumbo · 09-02-2023

Hey @Marius Gunnerud I have static route and default route for the network on the FTD. Also, I have a default static route on the gateway device that is connected to the FTD firewall as they are L3 connectivity.

SecurityJumbo · 09-02-2023

Hello @Marvin Rhoads You are right about. I tried to ping from internal device and it failed. Anyway, I tried to issue "packet tracer" command on the FTD using the same internal device IP "192.168.10.1" and the result is "Allow" as shown in the scree...

SecurityJumbo · 06-30-2023

Okay, I knew it there is something in the switch. I used another switch and the URL redirecting works fine.

SecurityJumbo · 06-29-2023

Hey guys, it is only one ISE and direct connection, No Proxy.No upstream firewall or ACL. No custom portal setting. Using the default one. I will try to change the setting and see if that helps

Member Since	‎04-28-2019 08:34 PM
Date Last Visited	‎10-18-2024 01:16 PM
Posts	20
Total Helpful Votes Received	1

User Statistics

User Activity

Cisco Unified Communications Manager CUCM API Failed

Firepower NAT Question

ISE Posture - No Policy Server Detected

Firepower-DNS Not Resolving

TrsutSec SGT Question

Re: Cisco Unified Communications Manager CUCM API Failed

Re: Firepower NAT Question

Re: Firepower NAT Question

Re: ISE Posture - No Policy Server Detected

Re: ISE Posture - No Policy Server Detected