Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello team,I'm using the following information for the CUCM to check the service status but it is failed and return the error message below. Please advise if I'm missing anything or this is a know issue with CUCM version 14.0 (my CUCM running (14.0....
Hello everyone,I'm trying to understand how the Firepower and NAT are working together. I have Firepower is configured with static and default route. It is working fine if I have the NAT policy configured, but when I remove the NAT rule the Firepower...
Hello guys,I'm deploying the ISE posture policy and I run into the AnyConnect Posture return "No Policy Server Detected" as shown below. The switch and machine are able to reach to the ISE ip and dns name.I created the ISEPostureCFG.xml file and save...
I have a FMC and HA FTD on HA mode version 7.3.1for both. The DNs server is connected via INSIDE interface only. The Firepower can ping the DNS server as shown below, but the DNS is failed. I configured the DNS and domainsearch. The DNS is not resolv...
Hello guys,I have been using ISE radius policy to assign the Security Group and it was working fine. Now, I'm using a third part tool to assign the SGT on the cisco switch interface (access port) using the SSH connection and keep the TrustSec policy ...
Hello @DavidStaudt Thank you very much for your response. I updated the request quesy as the following curl -k -v 'https://X.X.X.X:8443/controlcenterservice2/services/ControlCenterServices?wsdl' \--header 'Content-Type: text/xml;charset=utf-8' \--he...
Hey @Marius Gunnerud I have static route and default route for the network on the FTD. Also, I have a default static route on the gateway device that is connected to the FTD firewall as they are L3 connectivity.
Hello @Marvin Rhoads You are right about. I tried to ping from internal device and it failed. Anyway, I tried to issue "packet tracer" command on the FTD using the same internal device IP "192.168.10.1" and the result is "Allow" as shown in the scree...
