Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I'm trying to configure the SRGB value in ISIS to set the lower and upper bounds of the global label pool for segment routing using YDK and Cisco-IOS-XR-clns-isis-cfg. module: Cisco-IOS-XR-clns-isis-cfg+--rw isis+--rw instances+--rw instance...
Hi all, Fairly new to YDK and openconfig Yang models. Trying out some basic testing as below, just want to create a loopback interface on an NCS540 and getting a corruption and abort error. Any ideas on what may be causing this? Type "help", "copyrig...
Hi,
Well you can do it all on one interface if you like, there's no one correct way its just preference really. The one major error i think is the voip policy-map, that isnt required. Also the classes you call under the policy-maps require a capital ...
Ok quite a general question you've asked but i'll try my best to answer it for you. Yes you need to mark your packets, you can do that inbound on the LAN interface that will work fine. Mark using IP prec (0-7) or DSCP (https://www.tucny.com/Home/dscp...
By hard shutdown the neighbor, i of course mean neighbor x.x.x.x shut, not shut the interface! Last thing you want is to shut the interface and have to wait 180 seconds for the ISP to realise you're down (as there may be l2 devices inbetween you.)
There probably will be a glitch still with prepends as some ISPs, or the transit provider themselves, will be local preferencing via that route so won't move over to your other provider however many prepends you put onto the advertisement. Only way t...
