About GoodFeel

GoodFeel · 05-02-2019

Hello,I'm new on Cisco environment and I try to install a network with that. I activate the L3 Mode to get router functionnalities for my SF300. So, I create 2 VLAN (40 an 50). I affect some ports to this VLAN (VLAN 40= FE1 and FE2 and VLAN 50 = FE20...

GoodFeel · 05-09-2019

It's works !Now, I can join my VLAN_User from a client laptop without access to VLAN_Admin.I've changed the Port to VLAN configuration to map switch port to VLAN. Thank you Seb for your precious help.

GoodFeel · 05-09-2019

* Yes, I have reload my Cisco device after I activated the router mode which erased all my configuration. I set up all my configuration now. * The netmask is correct on all my client devices, I check it. * There is the output of commande sh ip route ...

GoodFeel · 05-03-2019

Hi Seb,From my device, I can ping the VLAN Gateway, yes, but I can't access to my NAS which is on the other VLAN.So : From my VLAN 40, I can ping gateway 192.168.40.254 but I can't ping the gateway of VLAN 50 (192.168.50.254) or others services.

GoodFeel · 05-02-2019

Hi Seb, Thank you for your help, I juste activate the router mode via CLI, I'd only activate L3 Layer ont the GUI. But now, I want that two VLAN can communicate. So since, VLAN 40, I can ping VLAN 50 and services hosted (NAS). May be I need to config...

Member Since	‎05-02-2019 05:54 AM
Date Last Visited	‎05-22-2019 12:07 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

SF300 - Inter vlan routing

Re: SF300 - Inter vlan routing

Re: SF300 - Inter vlan routing

Re: SF300 - Inter vlan routing

Re: SF300 - Inter vlan routing