Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
That's correct Alejandro, I'm not aware of a way to do that in ACS 5.2. If someone does know how to do it hopefully they will share it with us here. Perhaps you should start a new post on your issue specifically and see what kind of answers you get...
The only way I know to do that would be to create a custom privilege level in your device IOS configuration and associate the commands to that privilege level that you want users of that privilege level to be able to see/use. You would then have to ...
The users can see all the commands but they will only receive authorization to run the commands you specify in the command set. You also need to have your aaa configured to do command authorization against your ACS for this to work properly.
From looking at your attachment it would appear that the secondary ACS is trying to PXE boot from the network, is this how it should boot normally?If not then you might want to adjust the boot sequence for this device (BIOS setup) or, if the device w...
What you need to remember about the show running-config command is that the user running the command will only be allowed to see what they are authorized to configure. Keeping that in mind and so the tripwire user account can see "all" the running c...
