Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we are considering an FWSM but aren't sure how it will integrate into our network... Our core consists of a 6500 divided into approx 6 vlans... 1 Vlan for a residential network, (Further subnetted at the access layer) 4 vlans for an administra...
At the university of hartford, we would like for our leap authenticated users to be assigned an ip address by the ACS server itself, like a modem pool. Is it even possible to set up dhcp in such a way with ACS 3.0 so that only leap authenticated use...
I have been able to get Xircom wireless adapters to use the draft 8 standard when using LEAP authentication. However, they cannot use draft 10 due to the outdated firmware available for them. I wonder if it might be possible to flash them with airo...
So far I know that the aironet,airport, and xircom creditcard adapters are the only nics that support LEAP so far. I have also heard that Lucent cards support it as well. Can anyone confirm this? Anyone know of any other cards that can LEAP?
Thanks for the replies, I now understand the best way to implement the FWSM for our network. It doesn't look like transparent mode will work out but routed mode should work out fine. Our only issue is the use of VLAN1 (our largest administrative ne...
Yes, that was one of the caveats I read.. I wasn't sure if they were referring to 2 phys or SVI interfaces in the documentation.. Anyway if it can be done with routed mode that would be fine, I figured transparent mode would be simpler but I guess n...
I'm having the same problem with our wireless network, I'd like the users to be assigned addresses straight from the ACS itself, but I haven't had much luck.
