Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to make this work, I have a 9k in the middle that should bridge this together but I cant ping through. 10.1.1.1 --> Junos switch vlan 10 --> Asr9k {l2transport dot1q10 (bridge 10 with routed bvi) --> l2transport dot1q2000 (bridge 2000 wi...
I have full route table but I can not figure out where to add routes for advertisement? Nothing works. Can anyone help me out? route-policy PASS-ALLpassend-policyroute-policy IPV6-PASS-ALLpassend-policy#sh run router bgprouter bgp ###82nsrbgp router-...
I have been beating head against wall, I cant figure out problem. I have ### numbers for obvious reasons. What I do know is I have 100% connectivity over p2p's. From what I can tell I am set up correct, please can someone help. BGP router identifier...
That led me to solution, Dang.. Everything was setup correct on router.. Turns out the edge device did not have a return route. Added static and now all is good. I never looked at the interface counters, that was the key. Traffic was going out and no...
Vlans are set correct, Everything Pings.. I just cant Ping from source interfaces. Its almost like I can not use L2vpn bridge in a source ping. As matter of fact, I can ping the interface 172.16.0.1 from 10.x just cant get to 172.16.0.2 - 254.
Ping from ASR both networks are available and working, Just can not source ping from one to other.. interface BVI10ipv4 address 10.1.1.125 255.255.255.0!interface BVI2000ipv4 address 172.16.0.1 255.255.255.0Fri May 17 17:22:04.869 ETCType escape sequ...
