Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am using a Cisco Firepower 1140 as FTD, and I check this device every month.This month, I found that the Smart License registration was completely removed/unregistered. So I generated a new token and tried to register the device again, but th...
I need to deploy around 100–200 CBW140AC access points at a single site.Since Cisco’s recommendation is a maximum of 25 APs per controller, I’m considering dividing the deployment into multiple controller domains, each separated by different VLANs.
C...
Hi everyone,I'm running into an issue with IPTV multicast traffic on a Meraki MS120-48 switch and would really appreciate any insight or advice from the community.Issue Summary:IPTV set-top boxes experience frequent screen freezing when connected thr...
I was invited as a Network Admin. However, no devices are visible in the Network, and when I asked the Organization Admin, they said the devices have already been assigned. They also mentioned that once the devices are powered on and connected to the...
I believe only TAC engineers can change the buffer settings, and users cannot do so.I did not receive any guidance from the TAC engineer on how the settings were applied.However, one thing is clear: the problem was resolved after the settings were ap...
Yes. I will install CBW as controller.The CBW maximum AP numbers are 50 AP, but recommendation is 25 AP.I just want to know if I divide the VLANs on my switch, I couldoperate the multiple AP controllers on my switch.Because we can't provide other typ...
Hello everyone,Thank you for all your suggestions. Unfortunately, I had already tried most of what was recommended.I upgraded the firmware to 17.2.1, tested the switch using ports 1–24, and confirmed that the IGMP querier was functioning correctly. F...
This discussion is old, but I'd like to update it. I suffered from the same issue a few years ago and gave up on solving it. However, I encountered the same issue again today on my C1000-24T-4G-L, running 15.2(7)E6. The 'service unsupported-transceiv...
