Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have migrated from a AS 5516 to a NGFW 1140. Everything seems to be working great so far. What I was wondering is we have site-to-site tunnels configured and it appears the normal internet traffic is also trying to go through the tunnel. How can w...
We are starting to configure new firewalls to replace our old 5516x. I'm trying to find the easiest way to accomplish this. My plan was going to migrate ACL/Rules to FMC from the 5516x (Done) and then hook up the new firewalls so FMC can at least tal...
We just installed a few 9200 switched and for some reason the 1gig SFP module we put in 1/1/1 is showing connected to the tengig ethernet not the gig ethernet, how does one make it go on the gig? We are not using SFP+ so it shouldn't have gone onto t...
setting up a new 9300 and loaded it up and went through all the setup questions, not one asked me to assign an IP to the switch, I also can't find anything on the net that shows me how. I don't want to use DHCP, I can login with CLI so I know its all...
Good Morning guys,Thanks for the information. We have found the problem and it required some cleanup on our part. The vendor URL's that users were hitting was the same IP range that we had in the VPN Tunnel. Once we removed that range the sites stopp...
@Rob Ingram Thanks, sorry, the destination for the protected network on Node B is the IP of the partner, a state vendor. We see it leave the firewall under the events but most of the initiators info is blank and the response never gets back to us. Th...
So under the Node A protected networks, yes, all networks we want to be tunneled are there. As for the destination Node B protected Network, no internal networks defined there.
Thanks guys. I think I have it all squared away. Just plugging in the MGMT port and configuring it. We will run a couple cables and set different IP's to test and see if it passes traffic.Thanks Eric for the text file. I will look it over. I already ...
