Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,
I have 3 locations as showed in diagram which is connected with P2P link, primary & secondary for each location.
As you can see in Kurla-R1 router fa0/0 is Primary for Bangalore and Kurla-R2 is primary for Mhape(IDC).
I have to configure...
Hi Team, We have installed Cisco Controller with 22 AP's with one of our client. When we connected through AP the gateway which is configured in L3 switch pinging with high latency(File attached). We have configured multiple vlan, the SSID which c...
Hello Mark,
As you can see we need to have both router as active from LAN side.
How we can send traffic from LAN interface fa1/0 to Kurla-R1 for Banglore and Kurla-R2 for IDC R5 for specific destination.
and this is a P2P setup.
Thanks,
Vijay Gond
Hi Mark,
This is new installation and this this real setup and which routing protocol is useful on this scenario for easy to configure and monitor.
So please help me for the same...
Regards,
Vijay Gond
Hello,
WLC Model No-2504,
System Information
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.3.102.0
Bootloa...
