Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Im having some trouble with switching and BVIs. Im trying to setup an AP with local switching so i need a trunk port. This is my network setup. When I plug the AP directly into the switch below the router all the vlans work however when I have it...
Hi, I'm working with cisco wireless for the first time.Im trying to setup some access points with multiple SSIDs/Vlans and to have the access points work even if the VWLC goes down (its on the same network as the APs) . I have a VWLC setup on a hyper...
Ok. It was the vlan database. When I set one of the ports to an access port I got the following.(config-if)#switchport access vlan 11% Access VLAN does not exist. Creating vlan 11So I went to the vlan databaseafter entering vlan databasevlan 11vlan 1...
The switch is not a cisco and its configured for trunking (its an edgecore). I can ping the BVI interface IP addresses from devices connected to the switch on the same vlan. Here is the sh vlans outputVirtual LAN ID: 1 (IEEE 802.1Q Encapsulation) ...
Because its a ehwic ive had to add the following default vlans interface GigabitEthernet0/1/x switchport trunk native vlan 10 switchport trunk allowed vlan 1,2,10-12,1002-1005 switchport mode trunk no ip address This should work correct ? Because I c...
Yes everything under the DHCP section is disabled for the interface the wlans are on. Primary DHCP Server emptySecondary DHCP Server emptyDHCP Proxy Mode unticked Enable DHCP Option 82 unticked Enable DHCP Option 6 OpenDNS unticked So the local d...
