Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I recently bought a aironet 1815i air-ap1815i-e-k9c. I made sure it receives enough power and it boots up nice.I can connect to the CiscoAirProvision SSID and input my settings but after this the AP reboots and stays in the join/ discovery mod...
I am wondering why this is happening. After the reset my AP's LED keeps cycling between red green and amber. so i cant configure through web ui. I performed the reset with the mode button and held it down for less then 20 seconds during boot.
I mentioned that i made sure it is not a power issue i use a AIR-PWRINJ6= PoE injector.I turned out to be a ip issue. I set a static ip in my router for the ap but i set the same ip as management ip.After changing the ip in my router it worked.
model: aironet 1815i air-ap1815i-e-k9cpowerd by: Cisco AIR-PWRINJ6= PoE adapter & injectorbutBut that is not the problem it was working i just had to rest it. after that i had my problem.
