Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Cisco ME3600X doesn't support ACL in an output policy-map.One of our requirements is to perform traffic shaping for an up-link communication between two switches.So instead, classification via QoS-Group was configured. Kindly see below commands: ...
I need help for monitoring the redundant power supply of my switches (3750x and 3560x)
I have configured my snmp on my switches and is able to monitor interfaces, temperature and etc.
The problem is when I am monitoring the redundant power supply and...
Good day!I would like to ask for help, I am testing one of the configurations of our laboratory and I have encountered a problem and got confused.I tested the diagram below using packet tracer and physical hardware but arrived with different results....
Hi! I have a question regarding transparent firewalls using BVIs.Based from the diagram above, ASA1 is in Transparent mode.Port Gi0 is assigned BVI-1 and port Gi1 is assigned BVI-2.Is it possible for network 1 to communicate with network 2 ?The traff...
This is my topology. I have created two vlan (201 and 202)I want to create an access-list on the layer 3 switch.Server0 must be able to connect to server1 using HTTP only and deny any other ports.Server1 must also be able to connect to Server0 using ...
Hi Afrahmad,Okay, I shall try upgrading one of my switches and hopefully it fixes the bugs.Thank you very much for all your help.Have a great day!Franz UPDATE:I have upgraded the firmware from IOS 12.2(53)SE2 to 15.02-SE6 and now I am able to get the...
Hi Afrahmad,I am confused. Is there a way to use CLI for NMS? Can you enlighten me regarding this matter, I am not so experienced with monitoring system.Your help is highly appreciated.
