LMI is the protocol between the router's FR interface and the carrier's FR edge switch. If you disable keepalives on the FR interface, you're turning off LMI. This is a bad idea, since LMI keepalive packets let the router know when PVC's are up...
Charlie, You can use a MULTILINK interface to bond multiple T1 circuits, but be aware that 100% of the outbound packets will be Process switched. MPPP and the switching path add substantial load to the CPU. If you're just doing 2xT1 for one remote...
3gcasper, I haven't checked the specific module you mentioned. I'm assuming this card has the DSP chips to do VoIP analog to digital conversion. But many companies use a setup like this to do "toll bypass". Calls forwarded from the PBX are digit...
dasberry, Without looking at your particular topology, it sounds like you need to adjust some EIGRP routing metrics. This can be done in a number of ways. BW is the easiest, but if you have automated Performance tools that pull SNMP data from the...
