Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I am studying for the CCNP Encor and up until now I have been using GNS3 and eve-ng. I'm now looking at purchasing small physical switches as I am tired of learning that not all commands/functionalities work on simulated environments. Due to spac...
Hello,I will soon be configuring a stack of 9200L switches and as an engineer who has primarily dealt with 2960X switches up until now, I'm wondering whether there are any differences I need to be aware of when configuring them. For example, are ther...
Hello. I have a 9200L switch that was previously part of a stack that I removed the configuration from but it still seems to think it is part of a stack and I don't know how to remove.I ran the command no switch provision to remove the other stack me...
Hello. I may have to shortly be involved in configuring an (unmanaged ISP) edge router that will be installed at my organization. This is not something I have done before so I was hoping for some help to fully understand the steps that need to be tak...
Hello Joseph,Thanks for the response. I should have said that this is completely theoretical with the values being made up. I'm possibly overcomplicating things in my mind, just trying to breakdown the configuration at the network edge.
Hello Flavio,Thanks for the response. I should have said that my diagram is completely theoretical to map out what I think the configuration should be. So now I know that NATing should be done on the edge company device facing the ISP gateway (thanks...