Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am new at this, and I try to configure an HTTP server to be accessible from an outside network in Packet Tracer.Its pretty hard to describe, so I will try the best I can.At the moment all my seting are working from inside my network, the pro...
Hello,I hsd configure a dhcp with my dns server on my ASA firewall, It was working fine, but suddently, my dhcp client dosent receive my dns config at all, it show 0.0.0.0 insted of 10.0.1.50 that I have set.I tried to change the dns server in my con...
Hello, I am trying to lean how to set-up a firwall in packet tracer (I have nerver done it before) and I dont find any way to open my port for my web server.In my simulation, I have configured my nat adresses on the router. My web server il fonctiona...
Hello, I am trying to setup a network with a web server in a private network that should be availaible from an outside network.I have some probl;em with my routing route, and I have tried to give access to all ip by configurer ip route 0.0.0.0 on my ...
You solved all my problem!I would have not think about the router config, I was sure it was my firewall the problem!I would never thank you enough for helping me to fix this!You are helping me to get better! I wish you good fortune and have a good n...
Hello, I treid it, but the client was unable to reach dns server, so I put it back on (only in udp tho) and addes port 80 un udp also, but my client still dont generate an http trafic (it still block after the dns one and I get a time out)I tried to ...
Yes I know I havent deleted the useless server 0 I was using it for testing purpose.My http server is the server 10.0.2.50 and my dns server 10.0.1.50.Pc4 is only used to test my outside configuration.The website is climoilou.caAgain is only a testin...
