Hello to whom reading,    I have configured ipv4 addresses successfully in this topology (shown in the attachment) Though I am struggling fairly with configuring IPV6 and getting them to ping from one device to another based on the topology given. I have tried using link-local ipv6 unicast routing, ipv6 routing but no succession. I have tried finding guides on assisting me with this but I have had no succession with succeeding the task handed based on utilising various sources.    PC0 is the one having the most issues pinging as PC1 and PC2 cannot ping via IPV6 vice versa    Thank you  (Topology and packet tracer are placed below)  ... View more

Hello to whom reading,   I am fairly new at cisco packet tracer and a student that isn't very experienced with networking and such,    I am currently trying to configure ipv6 address based on the topology and the packet tracer files based in the IPv6 Configuration, Other Networking, IPvfiles below.    I am struggling on why the ipv6 addresses will not ping to one to the other based on the topology   Do  the ipv6 addresses need to change in order for them to be in the same network/subnet?   Thank you                ... View more

Hi,    I am currently struggling heaps with configuring the ipv4 and ipv6 addressing scheme, (packet tracer and the following scheme related with the packet tracer activity attached as a file) I am new at networking and don't really understand entire concept yet.    I am also struggling with answering these following questions relating to the packet tracer   What is the source and destination MAC address of the frame that travels from PC1 - R0 0/1?   What is the source and destination MAC address of the packet that travels from R2 - R3?   What is the source and destination MAC address of the packet that travels from R1 ­- R2? . If data is to be sent from PC2 – PC0, what will be the destination IPV4 address found on the packet between R0 – R1?   Much appreciated.  ... View more