cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
396
Views
0
Helpful
1
Replies
Highlighted

IPv6 Configurations issues

Hello to whom reading,

 

I am fairly new at cisco packet tracer and a student that isn't very experienced with networking and such, 

 

I am currently trying to configure ipv6 address based on the topology and the packet tracer files based in the IPv6 Configuration, Other Networking, IPvfiles below. 

 

I am struggling on why the ipv6 addresses will not ping to one to the other based on the topology

 

Do  the ipv6 addresses need to change in order for them to be in the same network/subnet?

 

Thank you 

 

 

 

 

 

 

 

1 REPLY 1
Highlighted
VIP Advisor

Re: IPv6 Configurations issues

Hi @KhaledJaber9762 

 

If your intention is to have connectivity between PCs using IPv6, then you must keep in mind that for this all your topology must have IPv6 configured, in addition to IPv4, either statically or dynamically.
But, routers do not automatically convert IP from IPv4 to IPv6.

If your intention is to ping directly connected routers using IPv6, then I recommend assigning an IPv6 manually to each router, following the same principles used for IPv4.

 

There are many useful guides on the internet and many videos that you could consult to exercise your knowledge.
If you are studying CCNA, I recommend consulting your instructor, as the personal guide is very useful.

 

Regards

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards


This widget could not be displayed.