Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a fresh cisco 3850 switch. After unboxing it i have create an L3 vlan, and connect a PC in same vlan with same subnetwork IP. But I am not able to ping L3 interface of switch from PC. I am able to do ping between two pc connected in same...
Hello,I have a cisco 2960 plus series switch and an SFP module. When I plug SFP in port the port goes in err-disable. After a shut, no shut the port's LED blink for once and it goes down again and the following message appears on the terminal. %GBIC...
Hello,I have one Cisco SG-300 10 PP switch. Earlier this was working fine but suddenly it stopped working. I took this device on the console to see what is happening and I got error messages as follows. I have tried with firmware upgrade but nothing ...
Hello Joseph,The IP address of pc is 10.0.0.2/8, and this is connected with port 1 which is in VLAN 1.I have connected two PCs in VLAN 1 with same subnet Ip addresses and they are pinging each other, but they are unable to ping 10.0.0.1 (defined as t...
Hi Seb,IP routing is enabled. But in the scenario I have mentioned above there is no need to enable IP routing as I am not doing routing between multiple vlans.
