Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, Just wondering if I need to create an inbound ACL on the ASA for it to establish a S2S tunnel?A lot of engineers say you need to, I understand if there is another firewall behind it that needs to establish a tunnel, but what if its just ...
Hi guys,We have a site with two primary and secondary layer 3 switches.HSRP is configured on both.192.168.1.2 as the Primary LAN interface192.168.1.3 as the Secondary LAN interface192.168.1.1 as the VIPBoth routers have been set up as a DHCP server.W...
Hi guys,Just a bit of sanity check here.As I have two Vigor 2860 series.HA is set up between both.192.168.1.2 as the Primary LAN1 interface192.168.1.3 as the Secondary LAN1 interface192.168.1.1 as the VIPBoth routers have been set up as a DHCP server...
Hi guys,I am doing practice questions to make sure what i have learnt is enough for my ccnp switch exam, and i may be wrong in this one.But from what i learnt in HSRP v1, that the the last 2 hexi decimal is the HSRP groupAnd in one of the questions i...
Hi guys,I am doing practice questions to make sure what i have learnt is enough for my ccnp switch exam, and i may be wrong in this one.But from what i learnt on UDLD, that if you leave it on normal mode, and one of the fibre links breaks lets say, t...
Thank you for the response. But what if now there is a parameter and an internal firewall. There is already an existing tunnel on the parameter firewall, and will need to port forward 4500 and 500 to the external IP of the parameter firewall to the i...
But then that means.I would need to configure that on the primary or active draytek.I don't have access to the primary device, via the LAN nor the WAN.Cannot remote on to it. Nor do we have remote hands.I can only configure on the secondary or standb...
We can't configure anything on the primary draytek as we can't remote on to it as WAN is down.And we don't have remote hands to unplug or shutdown the LAN interface for the primary draytek on site.So primary still remains up with the VIP I assume and...
Hi,We just saw your reply after my colleague posted the second post for the cisco vendors.We are doing that now for cisoc routers. But for the drayrek, we are unable to configure WAN tracking. But we are trying to break it down and understand the the...
