Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I would like to ask for your understanding on DCA section. Our current setting on Channel Assignment Method is Automatic and the interval set is 10 minutes. This works for both b/g and a radios. So I'm understanding that the controller should ...
Hi All,Some of our 702w APs in a single building is having random latency and packet loss. 702w AP in the other building are all working fine. I was suggested to upgrade firmware version first then trying out other actions if this suggestion fails to...
Hello,I found out that our WLC 5508 rebooted and/or crashed several days ago and the reason was due to Reaper Reset: Task "wipsTask" taking too much cpu: 99%. Attached is the complete crash log of our WLC. I bumped into this thread saying this issue ...
Hello, We have here only 1 Cisco 5508 WLC catering to 490+ APs (AIR-CAP702W and some AIR-CAP702I) running with software version of 8.0.140.0. These APs are connected to C2960X. I am monitoring these APs from my office. The issue is I am experiencing ...
Hi Remko,I know it's been so long before replying in this post. May I ask how were you able to know the ASIC groupings for WS-X4648-RJ45-E? I can only search for groupings of WS-X4448-GB-RJ45, WS-X4548-GB-RJ45, and WS-X4548-GB-RJ45V. My grouping mayb...
Hi Marco,I got the following setup. Do I need to change anything here?6 Mbps: Disabled9 Mbps: Disabled12 Mbps: Mandatory18 Mbps: Supported24 Mbps: Mandatory36, 48, 54 Mbps: Supported
Hi,Thanks for the reply. Channels 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, 161 are enabled for DCA Channel List in 802.11a/n/ac. Channels 36-48 are used by other APs but not listed in the screenshot.
Your version is 8.3.x and faced the same issue as mine. Hmmm. That gives me the only reason to upgrade it to the latest version, 8.5.151.0. Though I had to buy new set of APs since some are not supported by this release. I hope it solves my issue. St...
Hi Leo.Looks like it's currently disabled. My bad. Should I enable it? I only see the Controller Crash Info on WLC's GUI being useful at this time. (Cisco Controller) >show coredump summary
Core Dump is disabled
Core Dump file on flash:
SW Versi...