Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are setting up a new active/standby pair of
ASA 5585-X with SSP20 - 8-port 10/100/1000 and 2-port 10 GE
Since the total multi-protocol throughput is 5 Gb, there are various cabling options being discussed.
I have seen setups where they make the t...
Hello I have been working with XRv 5.1.1 runining in virtualbox which is running in GNS3. I would like to have more than 8 interfaces which is the max for the PIIX3 chipset. When I change it to ICH9 (supports 36 NICs), none of my interfaces work! Th...
you need the ssh license....S11K-SEC2-K9
so you get "SSH Server" when you do show license
css# show version
?Version: ap0500003 (5.00 Build 3)
?Flash (Locked): 4.10 Build 33
?Flash (Operational): 5.00 Build 3
?Type: PRIMARY
?Licensed ...
I am seeing this too.So it goes out as ICMP and returns UDP?????udp src 2.2.2..................icmp src outside:............... Is this why the ASA can't find a match?
Hello, Glad to see fresh post, usually they years old - not hours. My dot1x isn't working either - it allows access without any authentication with the configs below.I am running 12.2(33)SXI13. interface GigabitEthernet3/34 description c-41 cube 239 ...
This is a very old thread, but I had this issue today."......cannot create file..... ' is a little misleading.First I created the folders and that didn't work.Then I started to learn how to create certs on ubunutu using open ssl, but then came back t...
