Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two end hosts connected to an access port (via 3rd party, unmanaged switch). Both end hosts have static IPs. I have configured port security and ip source guard on that port in order to filter for both source IP and MAC, and configured static ...
Hello Team
I am running into the following issue using the Duo Admin API with Postman. When I run a GET request such as the following, I get an HTTP status code of 200 and a valid response.
https://{{duo-API-HOST}}/admin/v1/users?username=xxx.yyy
Whe...
Hello everyone,I have a Cisco WS-C2960CG-8TC-L switch which i recently upgraded from 12.2(something) to the new, recommended IOS Version 15.2.2E9(MD).The switch boots just fine with the new IOS and as far as I can tell it works correctly as it did be...
For those interested, I found the answer to my question here: https://github.com/postmanlabs/postman-app-support/issues/6078
Based on what I found out from this discussion, I made the following change to the Pre-Request Script and that way it works:
...
Hello again, I finally got the switch back in my office, did the factory reset and reconfigured it "by hand".Now the login works as expected (local login after RADIUS timeout). I presume there were some legacy AAA commands in the switch config that t...
Yes, three users are configured locally on the switch, but it doesn't make a difference which one I use or if I type in a username which doesn't exist on the switch. I get to enter the password and then it just stays there...Authentication methods ar...