Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear experts, Attached is the topology which I created for the lab purpose. I had configured IOU1 and IOU2 to act as the PC. That is by disabling "no ip routing" and "ip default-gateway" as 10.10.10.5 for IOU1 and 10.10.20.5 for IOU2.The IOU3 switch ...
Hello Experts, Could you please answer for my general question for the below requirement. Requirement: It is to remove the existing helper-address in the vlan and to add the new helper-address in the vlan. Assume the request is to remove the helper ...
Hello experts, I have WS-C3750X-48 switch running in HSRP. I am going to create the trunk port for connecting the server. Requirement is to add 4 trunk ports and 1 access port. Should I need to configure the trunk ports both in active and standby sw...
Hello experts, Could you please explain how to make the encrypted password for the local and enable authentication in Cisco IOS. I have tried as many password but does not work and shows the below error:(I could understand I should not use the level ...
Hello Experts, Required your help on the below. I got an required to remove one object-group in ASA. Before removing the object-group what are all the prerequisite should I check and also help me out with the show command, so it wont cause any impac...
Dear Balaji, Thanks for your answers. From IOU4 I could see the routing table for both segment 10.10.10.0/29 and 10.10.20.0/29. The traceroute from IOU1for 10.10.20.1 is reaching the 10.10.10.5(which is the gateway for vlan 10) and after that packet ...
