About spensleyj

spensleyj · 04-15-2011

We have a SF 300-48P setup in layer 2 mode with 2 static vlans; vlan 1 (data) and vlan 2 (voice) support Mitel IP phones. The unit has given us 3 months of trouble free service, recently however devices on vlan2 have been randomly disconnecting. Th...

spensleyj · 04-18-2011

Thanks for your response Dave. The following narrative and diagram might help clarify why the switch is configured in the way it is..Generally, I configure switches close to the following:When implementing a system that uses VLANs, the voice and dat...

spensleyj · 04-15-2011

This might be better answered by a Cisco person, but ... AFAIK the SGE2010P doesn't support CDP. However, the new SF 300 series of switches do support CDP, LLDP-MED, etc and are L3. The latest firmware for the SF 300 series isn't very old but I did ...

spensleyj · 04-15-2011

The SFE2000 is a Layer 3 switch, so is is capable of acting as basic router. However, the default configuration is generally Layer 2 so you'll have to connect to the switch with a console cable and change the mode to Layer 3 in order to enable routi...

Member Since	‎04-15-2011 11:58 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

sf 300-48P disconnect issue

Re: sf 300-48P disconnect issue

Re: SGE2010P Simple Question

Re: SFE2000 config. question