Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a data-flow diagram or other useful description of the process involved in servicing a DHCP request from a wireless device? The WAP125 Admin Guide describes the meaning of various configuration parameters, but I couldn't find anything more ...
The ATA191 Provisioning Guide (p.149) defines <Allowed_Remote_IP_Address> as:Description—Specifies a remote IPv4 address that is allowed access to the web-based configuration utility, when Remote Management is enabledUser Interface—Administration > M...
Hello,Now the SPA-series ATAs are no longer available, I'd greatly appreciate some advice concerning migration of the configuration to an ATA191. The non-default configuration for my own SPA112 is maintained in an XML V1.0 file and downloaded using ...
What is the architected method of initiating a three-way conference call with the SPA112 (i.e. with local mixing)?Some Cisco ATAs appear to use double-flash. The SPA112 has a "conference activation code" parameter which is blank by default, suggesti...
Pushing an XML configuration to an SPA112 using 'curl' as documented in the Provisioning Guide “Applying a Profile to the IP Telephony Device” page-36 doesn't appear to work on this OpenSuSE Linux system.This problem evidently arises because the ATA ...
Thanks, Flavio, that's probably the answer as I'd been assuming it worked as a low-level proxy (it's not a critical problem yet and I haven't yet checked). Presumably the DHCP request carries the MAC address of the user's mobile device, which is eas...
I have exactly the same customer problem, but with just one AP. Wired (Ethernet) clients in the same subnet work fine. Syslog reports that wireless clients are authenticated using WAP/Personal/AES, but that's where everything screeches to a halt. ...
HI Nattapong...Are you able to use the 'recall' button on your 'phone during an active call? If configured correctly AND supported by your VoIP service provider (*), this should place the active call on hold and play music to the other party while s...
I'm not RonZ, to whom you addressed your query, but I should point out that a straight firmware upgrade doesn't change the existing priviliged or unprivileged passwords. If your ATA was supplied by your ISP rather than bought off the shelf, then they...
