About arjunsawant

arjunsawant · 05-28-2011

Hi all,My Scenario is simple Lan, Wan (Two ISP) and DMZ.Can we connect Lan, Wan and DMZ cables on single switch (In small organization).It may be a security compramise.But Is it possible and how?Thnax.............

arjunsawant · 02-26-2011

Hi All..I have two Lease line Rel and tata between DC and DR with configuring eigrp load balancing.But due to some issue my management ask me that keep separete link for Storage Database and other traffic.So I have configured Route Map for NAS traffi...

arjunsawant · 09-18-2010

Hi all..I have one setup ....Mumbai-----Delhi with MPLS Ethernet link at both end.My connectivity is working fine..I am able to ping Mumbai to delhi.But problem is that when i ping from Delhi to Mumbai Lotus server with load 1473....ping 10.2.15.1 -l...

arjunsawant · 09-13-2010

Hi....I have cisco 1941 Router with IOS "c1900-universalk9-mz.SPA.150-1.M1.bin"But it shows only..Router(config)#ip sla ? key-chain Use MD5 authentication for IP SLAs Control Messages responder Enable IP SLAs ResponderWhich IOS would be require f...

arjunsawant · 08-10-2010

Hi all..I just want to know which routing prorocol is more cpu intensive.In one of my scenario i have to configure BGP or OSPF.Thanx....

arjunsawant · 05-29-2011

Hi..JD..Ya It's a Single Point Of Failure.But is there any workaround by configuring vlans/Private vlans for respective zone (LAN, ISP and DMZ-Wan).Thanx..

arjunsawant · 05-29-2011

Hi JD...Thanx for your reply..My concern is only that can we connect all the connections (ISP Cable, LAN cable, DMZ [Wan Router..Connected MPLS on branches] ) on a single switch (L2/L3) instead of dedicated switch.Thanx....

arjunsawant · 03-04-2011

Dear All,Thanx.....1. pease check the trace backwards from the Branch to the DC, just to isolate the issue to DC router.Branch#tracerouteProtocol [ip]:Target IP address: 10.0.0.100Source address: 10.2.15.1Numeric display [n]:Timeout in seconds [3]:Pr...

arjunsawant · 03-03-2011

Hi IAN..Good Morning..config is same which you given except "route-map PBR permit 30"Now I added this but the result is same..Tracert ,10.3.0.1192.168.3.3110.5.0.14910.5.0.15010.2.15.1Can You tell me why this command is require because I don't have d...

arjunsawant · 03-03-2011

Hi IAN..Pls find the latest config....Arjun........

Member Since	‎01-05-2006 02:40 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	124

User Statistics

User Activity

Wan, Lan and DMZ connect on single Swicth

Need Help in Route Map

Problem With MTU...

Cisco 1941 Router....IOS for IP Sla Monitor

Query..Router CPU Processing

Re: Wan, Lan and DMZ connect on single Swicth

Re: Wan, Lan and DMZ connect on single Swicth

Re: Need Help in Route Map

Re: Need Help in Route Map

Re: Need Help in Route Map