Hi all. I have a couple of 1921 routers. I've set up static routes on them using the "ip route <dest> <mask> <next hop>" command. When I do "show ip route", nothing shows up. However, when I do "show ip static route", they are there, but each of ...
Hi all,I just got my Cisco 2921 router out of the box, added a 4 port Gigabit module to it and powered it on. However, the router doesn't seem to recognize the 4 port module (show interfaces didn't show it). Is there anything special that I need to...
Hi all. I was just wondering if anyone know which routers support this QoS protocol? From my reading, any firmware from 12.2 should support it, but does it also depend on the router? A representative told me only the 3900 series router or the 7200...
On router 2, I have interface 0/0 set to 192.168.1.1 and interface 0/1 set to 192.168.10.1.On router 1, I have interface 0/0 set to 192.168.2.1 and interface 0/1 set to 192.168.10.2.The two routers are connected on their 0/1 interfaces. On their 0/...
show runBuilding configuration...Current configuration : 1391 bytes!! Last configuration change at 19:50:39 UTC Fri May 27 2011!version 15.1service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostn...