Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had a link connected to a Nexus 9K and port configurations as follows.--interface Ethernet1/11switchport mode dot1q-tunnelswitchport access vlan 822spanning-tree port type edgespanning-tree bpdufilter enablespeed 1000no negotiate auto-- Then, we m...
Can anyone please explain why the P2P subnet/neighborship represented as stub as follows in the LSDB ?Link connected to: another Router (point-to-point)(Link ID) Neighboring Router ID: 1.1.1.1(Link Data) Router Interface address: 10.3.13.3Number of T...
Hi All, We have a PIM domain that is running PIM-SPARSE mode and it's working fine. We have a customer who needs our multicast feeds. But we cannot allow PIM neighborships between us and the customer.So we decided to enable IGMP Static Join on the cu...
I am experiencing an issue with multicast feeds over a VTI. We have two VPN gateways at both source and receiver sites. From the receiver side, a static default route has been put in place towards the tunnel. On the source side, we have configured IG...
I am trying to establish an IPSec tunnel with a coustmer router but it fails. When I run a debug I can see below error message in the customer side. *Sep 21 15:53:47.528 UTC: map_db_find_best did not find matching map*Sep 21 15:53:47.530 UTC: %CRYPTO...
Hi @Ramblin TechActually, our requirement was to move the link on Nexus Ethernet1/11 to NCS-5501 Gi0/0/0/6 (hot cutover)The other side of the link is connected to a different organization, and we don't have access to it.My question is that link was w...
Hi Balaji, Thanks for replying.But why the link on NCS box started to pass traffic when auto-negotiation is enabled. Port was in up/up state before we make the change. Just wondering how auto-negotiation command triggered the data flow.
