Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had a link connected to a Nexus 9K and port configurations as follows.--interface Ethernet1/11switchport mode dot1q-tunnelswitchport access vlan 822spanning-tree port type edgespanning-tree bpdufilter enablespeed 1000no negotiate auto-- Then, we m...
Can anyone please explain why the P2P subnet/neighborship represented as stub as follows in the LSDB ?Link connected to: another Router (point-to-point)(Link ID) Neighboring Router ID: 1.1.1.1(Link Data) Router Interface address: 10.3.13.3Number of T...
Hi All, We have a PIM domain that is running PIM-SPARSE mode and it's working fine. We have a customer who needs our multicast feeds. But we cannot allow PIM neighborships between us and the customer.So we decided to enable IGMP Static Join on the cu...
I am experiencing an issue with multicast feeds over a VTI. We have two VPN gateways at both source and receiver sites. From the receiver side, a static default route has been put in place towards the tunnel. On the source side, we have configured IG...
I am trying to establish an IPSec tunnel with a coustmer router but it fails. When I run a debug I can see below error message in the customer side. *Sep 21 15:53:47.528 UTC: map_db_find_best did not find matching map*Sep 21 15:53:47.530 UTC: %CRYPTO...
Hi Balaji, Thanks for replying.But why the link on NCS box started to pass traffic when auto-negotiation is enabled. Port was in up/up state before we make the change. Just wondering how auto-negotiation command triggered the data flow.
Hi @paul driver ,Regarding your statement "You can indeed use /32 addressing to establish a "connection/peering or adjacency" between two devices" , could you please provide any documentation on how to implement it? I'm trying to implement a /32 IP a...
