Hi,Just installed and finished intail setup of ACS version 5.0 Sol. engine. Next i'm not able to acces solution engine over internet explorer. Even not able to telnet port 2002.Do i need to configure anything else for enabling gui in version 5.0?Plea...

Hi,I got new cisco 2951 router and NM-1T3/E3. Per datasheet NM-1 T3/E3 is supported with cisco 2951, but there is no slot space or connector in slot. Do i need some other hardware in addtion to install this card in router?Regards,Kamalkashyap_kamal@r...

Hi,I'm trying to regsiter Avaya 46XX series IP phone the CUCM 6.1(2), over SIP.I do have SIP enabled image with me for Avaya.Need advice,1) Is this doable or possible to register Avaya IP phone as 3rd Party IP phone?2) If answer is yes, then please d...

Hi,I have Cisco Call Manager version 6.0 running, in 'inside' zone of ASA 5520 Firewall, in my network. I'm trying to register Cisco IP phone connected in DMZ zone with CUCM running in inside zone.To achieve CUCM connectivity, have configured static ...

Hi All,I have ASA 5520 installed in network. This ASA is having SSM module with 4 gig ports.Can these ports on SSM module be utilized as normal interfaces of firwall? Is if , a saparate zone, for example DMZ1, can be introduce on the gig ports of SSM...