Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I’m using DUO for 2FA for windows logon, and we sync our solution with AD.
The issue is once the user exipered his password, the authentication with DUO failed and didn’t give the user to authenticate in order to change his password. any workourn...
Hello, we have an ASA 5525-X that is reimaged on FTD version 6.2.3. we restore configuration of FMC and after that the Firewall block all traffic, when we run a Packet tracer we found that the block is due to SNORT. but the SNORT isn't actived on our...
Hello, I have a C6807 in VSS mode, and I created a port channel with 3 interfaces connected to a router.The links in module 1 take traffic but the link in module 2 take just the input and output no as you can see below:sh int te 1/1/5 | i rate Queuei...
Hello, I have an ASR9K running on version 6.5.3I tried to connect a link between the ODF transmission and port 1G on ASR 1K and the port remain down. The port configuration: interface GigabitEthernet0/1/0/17ipv6 enable!interface GigabitEthernet0/1/0/...
Hello,Yes when i shut all the links in Chassis 1 in PO traffic is interrupted. The PO is facing an ASR 9K.VSS side:=========sh run int PO3Building configuration...Current configuration : 147 bytes!interface Port-channel3no switchportip address 192.16...
