Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There used to be a way to configure and up stream router to supply an IP address to a new down stream router and then allow tftp of the config. Is this still supported? I cannot find a document on how to set this up.
Sundar,Thanks for your reply. While the specific web page did not provide the exact configuration I needed, it did point me in the right direction.Chris
By 'very long', I meant pages and pages of entries in the translation table.I am unaware of any metric that monitors 'slowness'. We have experienced Internet slowness because the routers nat table is full and the router must clear an entry before a n...
Hello,You could try "show ip nat trans" to see the nat translation table. If it is very long when the web pages are slow, try clearing the nat translation table using the "clear ip nat trans *" command.If that corrects the problem, you might want to ...
