Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have ISE setup for our wired and wireless network. For our wireless network and wired networks, it will query AD to see if the device belongs to the membership of a specific group. Device Connects > Checks group Membership > Moves to defined ...
Hello, We are using ISE in our network for RADIUS authentication for our wireless network currently. Machines connect through a wireless network that is pushed through GPO, this verifies the machine is in the correct OU and AD group for access, and a...
We have two 4500-X layer 3 switches, one at each location running EIGRP and Layer 2. There are two connections between the 4500's that are trunk lines. We have about 30 VLANs, all of them are within the 10.x.x.x range. We have routing enabled, EIGRP ...
We have two Catalyst 4500-X L3 switches, one at our primary building and one at our secondary building. We have multiple VLANs setup for each department, servers, etc, with EIGRP routing the different subnets together.When I run wireshark on any comp...
We have VLANs 300-350 for our network, and VLAN 100 for our network management. VLAN 100 exists between the link from Core A to Core B as well.If I make all of the VLANs passive interfaces except for VLAN 100, EIGRP should function correctly, and thi...
