Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a user that wants to mark messages both Urgent and Private. He has that capability if he dials the main VM #, composes the msg and then sends it to a user. However, the same options are not available in ring-no-answer.Is the prompts for priv...
Check both Unity and the Switch for full duplex operation. This could affect quality on a "random" basis. I have seen this several times.Also, check for cpu and memory utilization. Doug
Check the processor utilization. If the processor is being taxed, it will drop or delay packets, even though your configuration is otherwise perfect.As I understand it, Frame relay fragmentation and low latency queuing is the preferred qos solution ...
No.The origional 802.3 10 base 5 spec was for 500 Meters.A little used 10 Broad36 supported 3.6 kM over a broadband system.The 10 Mb and 100 Mb fiber specifications are tipically for 2 KM.In order to keep costs low, the UTP specifications have been ...
If the frame-relay PVC is over a point-to-point t-1, the only way the PVC will go down is if the physical t-1 goes down. In this case the keep-alive’s and the PVC status are redundant. Think of Frame-relay in this configuration as an HDLC protocol ...
I found this information on a web site.The 3640 uses Fast Page mode RAM, Non-parity. 4 Meg by 32, 5V, 70 nsThe 1600 uses Fast Page mode RAM, Parity. 4 Meg By 36, 5V, 60 nsIt looks like the modules are simular, but different enough that the 1600 modul...
