Hello Cisco Experts! I'm really hoping someone on here can assist because I'm at the end of my proverbial rope. I battled this situation for 7 hours yesterday and put all of my considerable googling skills to the test, but alas I am admitting ...
Ok, so just a little summary since it looks like everything is working correctly 1. Was unable to access switch by any other method than mini-usb console via Putty - and for whatever reason with Windows 10, Putty wouldn't actually connect until I unp...
Perfect! I just found that exact response on another thread and that's done it. I added the reload and advise command at the end and confirmed it went directly to the correct image! Thank you.
You were only a few minutes too late! I just tried that and was able to go through the initial setup and save the config to NVRAM. I rebooted the switch and, while it looked like it was trying to boot from the wrong image initially, it then moved to...
Ok! Additional info! Apparently the 7th USB stick I found works! I was able to copy c2960x-universalk9-mz.152-2.E6.bin into the flash directory. Unfortunately output is as follows:Loading "flash:/c2960x-universalk9-mz.150-2.EX4/c2960x-universalk9-...
