Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Just trying to find what the recommended lowest ios is acceptable to use for Cisco to still be in support for them.the devices we have are the below, with their current versions:CISCO1921/K9 - Version 15.4(3)M8WS-C2960X-24TS-L - Version 15.0(2a)...
Hi Currently have a 1941 setup as a gateway device with a number of s2s VPN and with VPN client configured Is it possible to have this configured as anyconnect instead?I am having trouble finding if possible and if so how to get it done correctly Any...
Hi, Just a query on this. We are upgrading from a 5505 to a firepoewer 2100 with ASA platform on it. Basically i have migrated as much of the config as i can with a few minor amendments which wouldn't take in the new setup. We swapped over to the ne...
Hello, So a question with the C1100 one of our sites has decided to change to these routers because the old ones are end of line. Config copied on fine, however no external traffic works. using the using I have found that when you add a routes as th...
Hello, Just looking for a little advise. Basiclly we have a router with two circuits on it. The idea is that when one fails it will push over to the other and vice versa. We already have tracking in place for some routes on a circuit, but they want ...
The route for external and others are exactly the same as they were beforeObviously the equipment is not plugged in currentlyThe only details changed were having to have the vlans on the sub interfacesBut when that didn’t work we had to create a brid...
hi, Its not a true DMZ, its just called a DMZ in our systems all it does is pass the vlans from the router to the customer network. We got the internal network working so we know how that works now but the external for outside traffic is the issue ...
Hi What i had done was add ethernet1/1.1 with the vlan information which matched the others. When this happened there was no connections at all. Ethernet 1 is internal with vlan 12 is outside with vlan 2and 3 had our core DMZ (vlan 1 also) attached ...
Hi,Normally you would name the route. ip mask hop name EGhowever on this software, anything put after the hop goes down in the admindistance form on the GUI, there doesnt seem to be a way of naming the routeat all
Hello,Thanks, the name is only to name the next hop, ie like this internet/192.168.1.1.There is a tag feature which is only numbers, so it doesn't seem like itspossible at all.
